Lights

Home >> Standard Operating Procedures >> Lights

Fenced out during daytime

• Turn on Strobe and Full Position Lights.
• Viggen: Only Anti Collision Lights.

Fenced out at night or during really bad weather

• Turn on Strobe, Full Position Lights and Full Formation Lights.
• Viggen: All lights on.

Position lights to Steady or Flash?

• For aircraft that can set position lights to different modes (F-5E, A-10C, L-39C, F-16C etc), set the position lights to the Steady position.

When fenced in

• Turn all lights off. This is normally done by simply switching the master lights switch off.
• At night, or in poor weather, you may leave the lights on as needed if you need to stay in formation.

Taxi/landing lights

• When taxiing at an airport, turn taxi lights on when you are moving or about to move.
• When temporarily stopping, for instance when holding short of a runway, turn taxi lights off until you're about to move.
• Before landing on a runway, always turn landing lights on.
• In some aircraft (F/A-18C for instance) taxi and landing lights use the same switch.

During CASE 1 carrier ops

• Turn all lights off. This is normally done by simply switching the master lights switch off. Lights are off the whole flight, and only used when needed (formation passing through clouds or similar).
• Do not use taxi/landing lights during carrier ops.

During CASE 3 carrier ops

• When starting up on the boat, turn on Strobe, Full Position Lights and Full Formation Lights, but set the master lights switch to OFF, making your aircraft go dark.
• Just before taking off, when calling "Salute" and setting full power, set the master lights switch to ON, enabling all lights.
• Do not use taxi/landing lights during carrier ops.