Laser Guided Weapons

Home >> Weapon Emplyment Procedures >> Laser Guided Weapons

Considerations

In order to successfuly engage targets with Laser Guided Weapons a few requirements must be met.

1. LTD/LRFD, LSS/LST and LGW must use the same PRF code. (LGWs can't be guided using an IR Pointer.)
2. Designation of the target must be coordinated (time and duration) with the launch of the weapon in order for the weapon guided to see the reflection.
3. The weapon must be released within its "delivery envelope" (Direction and distans from target)
4. The weapon must be released from a predetermined direction.
5. Both LTD/LRFD (LSS/LST when used) and the LGW must have LOS to the target during the time of designation.

Capabilities

LGB

TBU

AGM-65 "Maverick"

TBU

AGM-114 "Hellfire"

TBU

AGR-20 APKWS

TBU

Procedures

Autonomous "Self Lasing"

TBU

Assisted "Ground/Buddy Lasing"

During assisted LGW employment procedures described below the aircraft/helicopter releasing the weapon will be referred to as the MULE and the aircraft/helicopter or JTAC designating the target as the GUIDER.

Static Guider

GUIDER acquires target position and decide on the appropriate direction of attack taking into account surrounding terrain, obstructing objects and orientation of the target.

- The position of the target can be specified in different ways. Some are described here but any method understood by both GUIDER and MULE can be used with regards to accuracy requirements for selected weapon.

- Only LTL is specified if the target is not obscured by terrain or objects. (Restrict only when necessary)

When done, GUIDER reports target position and LTL with direction of attack (if needed) to MULE.

Example:
Target in the open, target position given in MGRS and no restriction needed.

GUIDER: "Grid DU 2910 5784, Altitude 1534ft, LTL 360°"

Target located northeast of a building, target position given in Lat/Long and attack from southeast required.

GUIDER: "N66°19.93' E019°25.02', Altitude 1534ft, LTL 360°, Attack from Right"

Target located between two buildings, target position given as "known point" and specific attack heading required.

GUIDER: "Fire at target reference point Kilo, LTL 360°, FAH 340°±10°"

MULE reads back target position and restrictions given by the GUIDER, enters position into the system and carries out the necessary preparations for the attack. When ready to commence, MULE reports ready and specifies the laser code to be used.

Example:
MULE ready and PRF code 1615 in use.

MULE: "Ready, 1615"

Glossary

LASER BREVITY TERMS

• TEN SECONDS Standby for LASER ON call in approximately 10 seconds
• LASER ON Start/ acknowledge LASER designation
• SHIFT Shift LASER aimpoint.
• SPOT Acquisition of LASER designation
• CEASE LASER Discontinue lasing
• DEAD EYE LASER designator system inoperative
• NEGATIVE LASER LASER energy has not been acquired
• LASING The speaker is firing the LASER
• STARE Cue the LASER spot search/ tracker function on the specified location

Abbreviations

• LTD Laser Target Designator
• LRFD Laser Range Finder Designator
• LSS Laser Spot Search
• LST Laser Spot Track
• LGW Laser Guided Weapon
• PRF Pulse Repetition Frequency
• LOS Line of Sight
• LTL Laser-Target Line
• BDA Battle Damage Assessment