Aircraft Type Considerations

Home >> Technical Guides >> Aircraft Type Considerations

Fixed wing aircraft

F/A-18C Hornet

Typical missions: Strike, SEAD, Air Interdiction, CAS, CAP

F-16C Viper

Typical missions: CAP, Strike, CAS, Air Interdiction, SEAD

A-10C Warthog

Strengths

+ Air-to-Ground capability

+ Ordnance capacity (~15000 lbs)

+ Playtime/Time on Station

Weaknesses

- Slow

- Vulnerable from air threats

- Lack Anti-Radiation(HARM) and Anti-Ship(Rb15) capability

Mission Editor:

• WP

- WP2049 = Bullseye and is set automatically on misison start

- If possible, name important waypoints in ME. e.g Target WP = "TGT" or "Target"etc.

-The order in which the waypoints are listed/layed out should be:

1. Departure e.g "Exit North"(If specified/forced by missionmaker)
2. Hold/CP
3. Target
4. Arrival e.g "Entry East"(If known)

Navigation waypoints can be inserted where needed

e.g:

1. Exit North
2. WP 2
3. HOLD
4. TARGET
5. WP 5
6. Entry South

Tasks:

• Attack (BAI/CAS)
• Reconnaissance
• CSAR
• Aerial C2/AFAC

Specifications:

• Cruise Airspeed 300 knots*
• Combat Range ~250nm
• Normal Fuel Endurance ~2-3 Hours

* varies with environmental conditions and mission factors

Sensors:

• AN/AAQ-28 LITENING TGP (FLIR, CCD, LST, LRFD and IR-Pointer)

F-14B Tomcat

Strengths

+ Radar

+ AIM-54 Phoenix

+ Speed, Altitude and Range

Weaknesses

- SA (No HMD, no SA-page like Hornet/Viper)

- Lack Anti-Radiation(HARM) and Anti-Ship(Rb15) capability

Mission Editor:

• WP
  

  WP TID/Kneeboard

The F-14 can store up to 10 WP's in the kneeboard but only has 3 active WP in the system, WP 1-3, and these will be put in to the system by "Jester" during startup. Therefore it is recommended to set the most important WP for the mission as WP 1-3. WP4-10 will be added to the kneeboard (See picture)

If using a RIO, the RIO will have to put in WP's in to the system manually.

If using more then 10 WP's they need to be added to the brief to let the crew take notes.

- The order in which the waypoints are listed/layed out should be:

1. WP 1-3 Prioritized mission WP
2. WP 4-10 Additional WP
3. HB "Home Base" *

e.g:

1. WP 1 Nav point
2. WP 2 CAP East
3. WP 3 CAP East
4. WP 4 CAP North (alternative task)
5. WP 5 CAP North (alternative task)
6. WP 6 HB

* HB Waypoint must be the last WP and set to "Landing"

- Type specific WP

In ME the F-14 have a tab (same as Waypoints, Payload etc.) called "Navigation Target Fix Points". In "comment" naming the point as listed below (FP to set a Fixed point etc.) you can add one of each type-specifik point.

• FP = Fix Point, Generic fix-point waypoint.
• IP = Initial Point, Waypoint used for air-to-ground engagement
• ST = Surface Target, Waypoint indicating a surface target.
• DP = Defended Point, Waypoint used to show area to protect.
• HA = Hostile Area, Waypoint indicating a hostile area.

These points can be put in to the system manually by the RIO.

If so, use WP 4-10 in ME and be sure to tell the crew what is what in the brief. E.g: WP 4 = FP, WP 5 = ST etc.

Tasks:

• CAP
• Attack (BAI/CAS)
• Reconnaissance
• Aerial C2

Specifications:

• Cruise Airspeed ~470kts
• Normal Fuel Endurance ~2 (5k gallons/hour)

Sensors:

• LANTIRN TGP (FLIR, LRFD)

AJS 37 Viggen

Typical missions: Strike, Air Interdiction,

AV-8B Harrier

Typical missions: Air Interdiction, CAS, Strike

Helicopters

UH-1H Huey

Typical missions: Transport

Ka-50 Black Shark

Typical missions: Air Interdiction, CAS

Mi-24P Hind

Typical missions: Air Interdiction, CAS

AH-64D Apache

Strengths

+ Night capability

+ Longbow/AGM-114L (WIP)

Weaknesses

- Limited choice of ordnance / AGM-114 limitations

- SA (Link16, etc.)

Mission Editor:

• Primarily want to operate from FARP
• WP

The apache doesn't quite use the same method regarding flightplan (following wp1->2->3->4 etc.) but instead uses HA's and BP's and moves between them irregularly.

-The order in which the waypoints are listed/layed out should be:

1. Home Base
2. HA's (Should be a relatively safe area for collaboration and giving orders)
3. BP's within 4nm/8km from target (can be determined and entered inteo system during startup by the crew)

e.g:

1. Home Base
2. HA 1
3. HA 2
4. BP 1
5. BP 2
6. BP 3

Tasks:

• Movement to contact
• Attack (BAI/CAS)
• Reconnaissance
• Screen/Guard/Security
• Aerial C2

Specifications:

• Cruise Airspeed 110 to 120 knots*
• Normal Fuel Endurance ~2 Hours (average fuel burn: 150 gallons/hour)

* varies with environmental conditions and mission factors

Sensors:

• FCR is capable of detecting, classifying, and prioritizing targets without visual line of sight or in limited visibility, and engaging with RF Hellfire missiles. (WIP)
• RFI identifies and prioritizes radar emitters based on pre-designated signatures.(WIP)
• FLIR, DTV, LST and LRFD