STOVL CASE 1
Hoppa till navigering
Hoppa till sök
Home >> Standard Operating Procedures >> Carrier Ops >> STOVL CASE 1
Short Summary
Fixed-Wing
Departure
- Take off and turn left.
- Fly outbound until 7 NM DME.
- Push Tactical (Ch 3)
Recovery
- Flight leader contacts Marshal (Ch 16) at ~50 nm DME. Report flight members, position, altitude and lowest fuel.
- Approach the carrier, making sure you're on assigned altitude before 10 nm DME.
- When visual (typically 10 nm DME) report "see you at X nm". Switch to Tower (Ch 1). Go Fingertip Left formation.
- Tangentially enter the 5 nm diameter port hold (see image) at 250 kts at any point in this circle. Maintain Fingertip Left formation. The port hold circle is located to the left of the ship, with its rightmost point (point 1) being right above the boat.
- Flights at angels 2 commence at point 3 in the hold, going Echelon Right formation and accelerating to 350 kts, slowly descending to 800'.
- As flights commence, the flights above descend in 1000' steps maintaining SA by looking around, aircraft sensors and (if absolutely necessary) comms.
- Break at 800 ft and 350 kts shortly after the bow. 17 second intervals between each break.
- Aim for 1.2 nm from the boat when abeam, at 600 ft. Turn final immediately (i.e. when you got the boat on your 9 o'clock) and land.
Rotary-Wing
Departure
- Take off to a hover and perform a small clearing turn to end up close aboard port side of the ship.
- Turn left and fly outbound to 0.5 NM DME.
- Arc left.
- Fly outbound on departure radial until 7 NM DME.
- Push Tactical (Ch 3)
Recovery
- Flight leader contacts Marshal (Ch 16) at 10 NM DME. Report flight members, position, altitude and lowest fuel.
- Approach the carrier, making sure you're on assigned altitude before 5 NM DME.
- When visual, report "Ship in sight".
- Switch to Tower (Ch 1) at 5 NM.
- Enter overhead Delta pattern from astern.
- Wait for the "Charlie" call, if not briefed, then decend to Alpha pattern.
- Break shortly after the bow. Pilots within flight extends upwind for proper intervals between each break.
- Land at assigned spot.
Resources
Detailed Instructions
Fixed-Wing
Departure
On The Boat
Takeoff
Recovery
Arriving to the Carrier Control Zone
Entering the Port Hold
Exiting the Port Hold
Entering the Break
The Final Turn
Bolters and Waveoffs
On the Deck
Spins
Rotary-Wing
Departure
On The Boat
- Set radio to Tower (Ch 1)
- When your flight is ready to depart, taxi to the forward port slots (1-4). Do not request taxi. Only use comms if needed to sort out issues.
Takeoff
- Take off to a hover at 50ft and perform a small clearing turn to end up close aboard port side of the ship. If on spot 3 and 3A, make sure spot 2 and 4 are clear before takeoff.
- Turn left 10-100 degrees and fly outbound on relative radial 260-350 to 0.5 NM DME.
- Arc left at 0.5 NM DME until interception of departure radial.
- Fly outbound on departure radial until 7 NM.
- Push Tactical (Ch 3)
Recovery
Arriving to the Carrier Control Zone
Entering the Port Hold
Exiting the Port Hold
Entering the Break
The Final Turn
Bolters and Waveoffs
On the Deck