F/A-18C Hornet Syllabus Test

Från Master Arms Wiki
Hoppa till navigering Hoppa till sök

Home >> Aircraft Syllabi >> F/A-18C Hornet Syllabus Test

Basic Section

Basic Flying

Starting Up

  • Cold Start using Quickstart Checklist

Basic Navigation

  • Navigate visually between two points using the compass and an empty F10 map
  • Waypoint Navigation
  • TACAN Navigation
  • Using SA page to find wingman
  • Course Line
  • Autopilot BARO hold
  • Standard Climb (Military Power, use pitch to maintain 300 kts IAS)
  • Waypoint Handling
    • Setting coordinate system (MM:DEC vs MM:SEC) and PRECISION
    • Creating waypoints (HSI, UFC, POSITION/ELEVATION)
    • Inserting waypoints into sequences (HSI, SEQUFC, INS)
  • BRA calls
  • Understanding Radials and determine what radial you are on relative to steerpoints and TACAN stations
  • Bullseye usage
    • Setting a WP as Bullseye (HSI, DATA, A/A WP)
    • Reading own and cursor bullseye position in Radar

Landing

  • On-speed Flying
    • Level Flight (Pick an altitude, dirty up and go on-speed maintaining altitude)
    • Turning (Perform ~30 degree bank turns maintaining altitude)
    • Careful climbing and descending (around 500 feet/minute)
    • Quickly going from ordinary flight (around 350 kts IAS) to on-speed flying.
  • Landing (~500-700 feet/minute, no flare, extend speed brake if full stop)
  • Traffic Pattern Touch'n'Go Practice (maintain on-speed, climb to 1500', turn downwind to end up ~1.5 NM from course line, turn final and descend when wingtip passes runway threshold)
  • Overhead break (Approach in runway direction, 300 kts IAS, 1500'. Break over runway, enter downwind and land as explained above) http://wiki.masterarms.se/index.php/Fil:OverheadBreak.png

Basic Mission Procedures

  • Checking in
  • Fence In / Fence Out procedures
  • Changing radio presets
  • Jettison Settings
  • Joker/Bingo Settings
  • Formation Takeoff (2-ship)

Basic Combat

Basic Air-To-Air

  • RWS Radar Mode
    • Setting Range, Azimuth (i.e Width), Bars and Elevation
    • One TDC depress for LTWS soft lock, two presses for STT hard lock
  • Boresight Acquisition Mode (Sensor Switch Up)
  • Fire AIM-120C Amraam (~10-20 NM)
  • Fire AIM-9X Sidewinder (~2-4 NM)
  • Raygun / Buddyspike procedures
  • "Fox" and "Splash" Calls
  • Fire AIM-120C Amraam in TWS mode against multiple targets
  • Fire AIM-9X using JHMCS with uncage button for off-boresight shots
  • Vertical Acquisition mode
  • Crank and Short skate maneuver

Basic Air-To-Ground

  • General Purpose Dumb Bombs (Mk 82, Mk 83, Mk 84)
    • Configuration (MFUZE (Nose), QTY, MULT and INTERVAL settings)
    • Standard CCIP drop (Start from 8000', roll in, ~30 degree dive angle, 400-500 kts, drop at ~4000' and pull up) Examples: https://www.youtube.com/watch?v=gVuLCGKKqvI
  • High angle gun strafing (Start from 8000', roll in, ~30 degree dive angle, 400-500 kts, fire short burst at ~3000' and pull up) Example: https://www.youtube.com/watch?v=bdaBRMG5yN4
  • Fire HARM in SP and TOO modes
  • Drop JDAM in TOO mode
  • Targeting Pod Usage (Designation and Laser)
  • Drop GBU-12 LGB in AUTO mode (self lasing using T-pod)
  • Fire AGM-65E Laser Maverick (self lasing using T-pod)

Basic Defence

  • Drop Flares and Chaff in Dispenser Bypass mode
  • Putting EW symbology in HUD
  • Evade enemy missile by putting it on your 3 o'clock or 9 o'clock (Evaluate in TacView)

Advanced Section

Aerial Refueling

  • Use radio menu to contact correct tanker
  • Locate and form up on tanker's left wing (echelon left formation)
  • Hooking up and receiving fuel, straight and through turns
  • Moving to right side after refueling (echelon right formation)

Carrier Ops

  • Learn CASE 1 Recovery
  • Learn CASE 1 Departure (fly BRC at 300 kts IAS 500' until 7 NM before climbing and forming up)
  • Learn to fly the full CASE 1 approach as a wingman, holding formation through approach, port-hold, commencing and initial
  • Learn to fly the full CASE 1 approach as a lead, including communicating with Marshal and Tower
  • Learn CASE 3 Departure
  • Learn CASE 3 Recovery